Dhaka University Journal of Applied Science & Engineering

Robust Signal Denoising Techniques for Highly Accurate and Spatial Resolution Preserved Brillouin Optical Time Domain Analysis Sensors

• Abul Kalam Azad
  Department of Electrical and Electronic Engineering, University of Dhaka, Dhaka-1000, Bangladesh

Distributed optical fiber sensors, Non-local means filter, Anisotropic diffusion filter, Lorentzian function, Least-squares curve fitting

The diminution of measurement uncertainty to an acceptable level and the preservation of experimental spatial resolution are highly desirable in many real-world applications of Brillouin optical time domain analysis (BOTDA) sensors. In practical applications of such sensors, the measurement uncertainty essentially relies upon the signal-to-noise ratio (SNR) of the experimental Brillouin gain spectra (BGSs) obtained throughout the sensing fiber. The improvement of such SNR using improper signal denoising techniques alters the experimental spatial resolution of the BOTDA sensors. In this paper, the use of non-local means filter (NLMF) and anisotropic diffusion filter (ADF) is experimentally demonstrated to enhance the uncertainty in the measurement of temperature using BOTDA sensors. For this purpose, the BGSs along a 41 km fiber are collected by averaging several numbers of BOTDA-traces from BOTDA hardware setup. Such BGSs are first denoised by employing NLMF and ADF to improve the measurement SNR. The Brillouin frequency shifts (BFSs) of denoised BGSs are then extracted via curve fitting technique (CFT). The BFS distribution is finally mapped to temperature distribution depending on the known BFS-temperature relationship of the sensing fiber. The robustness of the used filters is analyzed rigorously in terms of SNRs of BGSs, uncertainty in temperature extraction, spatial resolution and runtime in signal processing. The results indicate that the utilization of NLMF and ADF can enhance the SNRs of BGSs up to the maximum of 15.64 dB and 13.53 dB, respectively. Consequently, the uncertainties in the temperature extraction can be reduced up to the maximum of 52.63% and 57.31% for using NLMF and ADF, respectively. Moreover, both NLMF and ADF can preserve the experimental spatial resolution of the BOTDA sensors and include insignificant runtime to CFT. Thus, NLMF and ADF can be considered as robust signal denoising techniques for highly accurate and spatial resolution preserved BOTDA sensors.

1. A. Coscetta, A. Minardo, and L. Zeni, “Distributed Dynamic Strain Sensing Based on Brillouin Scattering in Optical Fibers,” Sensors 5629, 20(19), pp 1-23, 2020.
2. P. Lu, N. Lalam, M. Badar, B. Liu, B. T. Chorpening, M. P. Buric, and P. R. Ohodnicki, “Distributed optical fiber sensing: Review and perspective,” Appl. Phys. Rev, 6, pp 1-35, 2019.
3. J. Li, X. Zhou, Y. Xu, L. Qiao, J. Zhang, and M. Zhang, “Slope-assisted Raman distributed optical fiber sensing,” Photon. Res., 10(1), pp 205-213, 2022.
4. N. Lalam, P. S. Westbrook, J. Li, P. Lu, and M. P. Buric, “Phase-Sensitive Optical Time Domain Reflectometry With Rayleigh Enhanced Optical Fiber,” IEEE Access, 9(1), pp 114428-114434, 2021.
5. A. K. Azad, F. N. Khan, W. H. Alarashi, N. Guo, A. P. T. Lau and C. Lu, “Temperature extraction in Brillouin optical timedomain analysis sensors using principal component analysis based pattern recognition,” Opt. Express, 25(14), pp 16534- 16549, 2017.
6. Q. Zhang, T. Wand, J. Zhao, J. Liu, Y. Wang, J. Zhang, L. Qiao, and M. Zhang, “ A Dual-Adaptive Denoising Algorithm for Brillouin Optical Time Domain Analysis Sensor,” IEEE Sensors Journal, 21( 20), pp 22712-22719, 2021.
7. X. Angulo-Vinuesa, S. Martin-Lopez, P. Corredera, and M. Gonz´alez-Herr´aez, “Raman-assisted Brillouin optical timedomain analysis with sub-meter resolution over 100 km,” Opt. Express, 20(11), pp 12147-12154, 2012.
8. S. Wang, Z. Yang, S. Zaslawski, and L. Thévenaz, “Short spatial resolution retrieval from a long pulse Brillouin optical timedomain analysis trace,” Opt. Lett., 45(15), pp 4152-4155, 2020.
9. N. D. Nordin, M. S. D. Zan, and F. Abdullah, “Comparative Analysis of the Deployment of Machine Learning Algorithms in the Distributed Brillouin Optical Time Domain Analysis (BOTDA) Fiber Sensor,” Photonics 79, 7(4), pp 1-13, 2020
10. M. A. Soto, and L. Thévenaz, “Modeling and evaluating the performance of Brillouin distributed optical fiber sensors,” Opt. Express, 21(25), pp 31347-31366, 2013.
11. A. Dominguez-Lopez, A. Lopez-Gil, S. Martin-Lopez, M. Gonzalez-Herraez, “Signal-to-Noise Ratio Improvement in BOTDA Using Balanced Detection,” IEEE Photon. Technol. Lett., 26(4), pp 338 - 341, 2013.
12. M. A. Farahani, E. Castillo-Guerra, and B. G. Colpitts, “Accurate Estimation of Brillouin frequency shift in Brillouin optical time domain analysis sensors using cross correlation,” Opt. Lett., 36(21), pp 4275-4277, 2011.
13. H. Iribas, A. Loayssa, F. Sauser, M. Llera, and S. L. Floch, “Cyclic coding for Brillouin Optical Time-Domain Analyzer using probe dithering,” Opt. Express, 25(8), pp 8787-8800, 2017.
14. C. Zhao, M. Tang, R. Liao, H. Wu, and S. Fu, “SNR-Enhanced Fast BOTDA Combining Channel Estimation Technique with Complementary Pulse Coding,” IEEE Photonics. J., 10(5), pp 1-10, 2018.
15. X. Jia, and Y. Rao, L. Chang, C. Zhang and Z. Ran, “Enhanced sensing performance in long distance Brillouin optical timedomain analyzer based on Raman amplification: Theoretical and experimental investigation,” J. Lightwave Technol. 28(11), pp 1624–1630, 2010.
16. M. A. Soto, X. Angulo-Vinuesa, S. Martin-Lopez, S. Chin, J. D. Ania-Casta˜non, P. Corredera, E. Rochat, M. Gonzalez- Herraez, and L. Th´evenaz, “Extending the real remoteness of long-range Brillouin optical time-domain fiber analyzers,” J. Lightwave Technol. 32(1), pp 152–162, 2014
17. M. A. Soto, M. Taki, G. Bolognini, and F. D. Pasquale, “Simplex-coded BOTDA sensors over 120 km SMF with 1-m spatial resolution assisted by optimized bidirectional Raman amplification,” EEE Photon. Tech. Lett. 24(20), pp 1823- 1826, 2012.
18. M. A. Soto, J. A. Ramírez, and L. Thévenaz, “Intensifying the response of distributed optical fibre sensors using 2D and 3D image restoration,” Nat. Commun. 7:10870, 2016
19. A. K. Azad, “Analysis of 2D Discrete Wavelet Transform Based Signal Denoising Technique in Brillouin Optical Time Domain Analysis Sensors,” The Dhaka University JASE, 5(1&2), pp 1-8, 2020.
20. M. A. Farahani, M. T. V. Wylie, E. Castillo-Guerra, and F. G. Colpitts, “Reduction in the number of averages required in BOTDA sensors using wavelet denoising techniques,” J. Lightwave Technol., 30(8), pp 1134–1142, 2012.
21. A. K. Azad, “Extraction of Temperature Distributions in Brillouin Optical Time Domain Analysis Sensors Using 2D Wiener Filter Based Matched Filter Detection,” The Dhaka University JASE, 6(2), pp 30-38, 2021.
22. P. Zhang, B. Wang, Y. Yang, A. K. Azad, K. Luo, K. Yu, C. Yu, and C. Lu, “SNR enhancement for Brillouin distributed optical fiber sensors based on asynchronous control,” Opt. Express, 30(3), pp 4231-4248, 2022.
23. K. Luo, B. Wang, N. Guo, K. Yu, C. Yu, and C. Lu, “Enhancing SNR by Anisotropic Diffusion for Brillouin Distributed Optical Fiber Sensors,” J. Lightwave Technol., 38(20), pp 5844-5852, 2020.
24. B. Wang, L. Wang, C. Yu, and C. Lu, “ Long-distance BOTDA sensing systems using video-BM3D denoising for both static and slowly varying environment,” Opt. Express, 27(25), 36100-36113, 2019.
25. X. Qian, X. Jia, Z. Wang, B. Zhang, N. Xue, W. Sun, Q. He, and H. Wu, “Noise level estimation of BOTDA for optimal non-local means denoising,” Appl. Optics, 56(16), pp 4727- 4734, 2017.
26. B. K., S. Kumar, “Image denoising based on non-local means filter and its method noise thresholding,” Signal, Image and Video Processing, 7(1), pp 1211-1227, (2013).
27. K.M. Prabusankarlal, R. Manavalan, and R. Sivaranjani, “An optimized non-local means filter using automated clustering based preclassification through gap statistics for speckle reduction in breast ultrasound images,” App. Computing and Informatics, 14(1), pp 48-54, 2018.
28. P. Perona and J. Malik, “Scale-space and edge detection using anisotropic diffusion,” IEEE Trans. on Pattern Analysis and Machine Intelligence, 12(7), pp 629-639, 1990.
29. C. Tsiotsios, and M. Petrou, “On the choice of the parameters for anisotropic diffusion in image processing,” Pattern Recognition, 46(1), pp 1369-1381, 2012.
30. J. Immerkær, “Fast Noise Variance Estimation,” Computer Vision and Image Understanding, 64(2), pp. 300-302, 1996.
31. J. Hu and Y. P. Luo, “Non-local means algorithm with adaptive patch size and bandwidth,” Optik, 124(22), pp. 5639-5645, 2013.
32. A. K. Azad, L. Wang, N. Guo, H. Y. Tam and C. Lu, “Signal processing using artificial neural network for BOTDA sensor system,” Opt. Express, 24(6), pp 6769-6782, 2016.
33. Y. P. Chaudhari, and P. M. Mahajan, “Image denoising of various images using wavelet transform and thresholding techniques,” Int. Research. J. Engg. Technol. 4(2), pp 517-523, 2017.